Toro 74950, Operator'S Manual

Page: 25 / 68

Adjusting the Height-of-Cut Pin
The height of cut is adjusted from 25 to 140 mm (1 to 5–1/2
inches) in 6 mm (1/4 inch) increments by moving the clevis
pin into different hole locations.
1. Move the transport lock to the lock position.
2. Push on the deck-lift pedal with your foot and raise the
mower deck to the transport position (also the 140 mm
(5–1/2 inch) cutting-height position); refer to
Figure
27 .
3. To adjust, rotate the pin 90° and remove the pin from
the height-of-cut bracket (
Figure 27 ).
4. Select a hole in the height-of-cut bracket corresponding
to the height of cut desired, and insert the pin (
Figure
27 ).
5. Push on the deck lift, pull back on the transport lock,
and slowly lower the mower deck.
Figure 27
1. Deck-lift pedal 3. Transport lock
2. Height-of-cut pin
Adjusting the Anti-Scalp
Rollers
Whenever you change the height of cut, it is recommended to
adjust the height of the anti-scalp rollers.
1. Disengage the blade-control switch (PTO), move the
motion-control levers to the N
EUTRAL
-
LOCK
position,
and set the parking brake.
2. Shut off the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Adjust the anti-scalp rollers as shown in Figure 28 ,
Figure 29 , and Figure 30 .
g029955
Figure 28
1. Anti-scalp roller 4. Flange nut
2. Spacer 5. Bolt
3. Bushing
g029956
Figure 29
1. Anti-scalp roller 3. Flange nut
2. Bushing 4. Bolt
g029957
Figure 30
1. Anti-scalp roller 4. Flange nut
2. Spacer 5. Bolt
3. Bushing
25