Toro 68038, Operator'S Manual, Page: 43 / 57

Checking the Transmission Neutral Position (continued)
g358000
1. Put the hopper in the dump position and
shut off the engine.
2. Remove the cowl .
3. Remove the throttle lever cables at the
transmission.
4. Lift the front wheels off the ground, and
support the machine with a jack stand.
5. Start the machine. Increase the engine throttle
to full speed while checking for front drive
wheel rotation.
Note:
If the wheels rotate, proceed to the next
step. If the wheels do not rotate, shut off the
engine and install the control cables and cowl.
6. Note the directional movement of the front
drive wheels. Shut off the engine.
7. Remove the hardware securing the screen to
the frame
and .
8. Remove the screen .
9. Remove the transmission cover plate .
10. Loosen the lock down screw until the return
arm can be rotated.
Note:
If wheels rotate forward, rotate the
return arm counterclockwise. If wheels rotate
backward, rotate the return arm clockwise.
11. Tighten the lock down screw and check the
front drive wheel rotation.
Inspecting the Tires
Inspect tires for cuts, slashes, or bulges. Tires with defects need to be replaced or repaired
for proper handling and safety.
Torquing the Wheel Lug Nuts
Torque the lug nuts at the front and rear wheels in a crossing pattern to 122 N∙m (90 ft-lb) .
3451-702A Page 5–12 Maintenance: Drive System Maintenance