20
Stopping the Engine
1.
Press the brake to stop the sprayer.
2.
Pull the parking brake lever up and back to set it.
3.
Move the range selector out of gear into the Neutral
position.
4.
Turn the ignition key to the Stop position.
5.
Remove the key from the switch to prevent accidental
starting.
New Sprayer Break-In
To provide proper performance and long sprayer life,
follow these guidelines for the first 100 operating hours:
•
Check the fluid and engine oil levels regularly and be
alert for indications of overheating in any component of
the sprayer.
•
After starting a cold engine, let it warm up for about
15 seconds before accelerating.
•
Avoid hard braking situations for the first several hours
of new sprayer break-in operation. New brake linings
may not be at optimum performance until several hours
of use has caused the brakes to become burnished
(broken-in).
•
Avoid racing the engine.
•
Vary the sprayer speed during operation. Avoid fast
starts and quick stops.
•
Refer to the Maintenance section for any special low
hour checks.
Transporting the Sprayer
For moving the sprayer long distances, use a trailer. Secure
the sprayer to the trailer. Figure 17 illustrates the front
tie-down points.
1
1
Figure 17
1. Tie down points
The rear tie-down points are two steel loops under the back
of the frame just in front of the adjustable boom frame.
Towing the Sprayer
In case of an emergency, the sprayer can be towed for a
short distance. However, we do not recommend this as a
standard procedure.
Towing at excessive speeds could cause a loss of
steering control, resulting in personal injury.
Never tow the sprayer faster than 5 mph (8 kph).
Warning
Towing the sprayer is a two person job. If the machine must
be moved a considerable distance, transport it on a truck or
trailer; refer to Transporting the sprayer, page 20.
1.
Affix a tow line to the frame.
2.
Put the range selector in the Neutral position and release
the parking brake.
3.
Tow the sprayer at less than 5 mph (8 kph).
Sprayer Controls and
Components
Master Boom Switch
The master boom switch allows you to start or stop the
spray operation. Press the switch with your foot to enable
or disable the spray system (Fig. 18). When the master
switch is off, the Spray Pro screen reads “Hold.”
1
Figure 18
1. Master boom switch
Boom Switches
The boom switches are located at the front of the control
panel to the right of the seat (Fig. 19). Toggle each switch
forward to turn the corresponding boom section on and
rearward to turn them off. When the switch is turned on, a
light on the switch illuminates. These switches will only
affect the spray system when the master boom switch is on.
Summary of Contents for 41165
Page 51: ...51...
