34
4.
Install the air cleaner cover and knob (Fig. 31).
5.
Close and latch the seat.
Servicing the Engine Oil
Change the engine oil and oil filter after every 100
operating hours.
Oil Type:
Detergent oil (API service SG or SH)
Crankcase Capacity:
w/filter, 2.1 qts. (2.0 l)
Viscosity:
Refer to the following table.
F
–20
0
20
40
60
80
100
°
C
–30
°
–20
–10
0
10
20
30
40
USE THESE SAE VISCOSITY OILS
32
Changing the Engine Oil
1.
Start the engine and let it run for five minutes. This
warms the oil so it drains better.
2.
Set the parking brake, stop the pump, stop the engine,
and remove the ignition key.
3.
Release the latch on the back of the seat and lift the seat
forward.
Components under the seat will be hot if the
sprayer has been running. If you touch hot
components you may be burned.
Allow the sprayer to cool before performing
maintenance or touching components under the
hood.
Caution
4.
Place a pan below the oil drain.
5.
Remove the drain plug (Fig. 34).
1
Figure 34
1. Oil drain plug
6.
When the oil has drained completely, replace the drain
plug and torque it to 10 ft-lb (13.6 N
⋅
m).
7.
Dispose of the used oil at a certified recycling center.
8.
Slowly pour approximately 80% of the specified
amount of oil into the oil filler tube (Fig. 35).
1
Figure 35
1. Oil filler tube
9.
Check the oil level; refer to Checking the Engine Oil
Level, page 14.
10.
Slowly add additional oil to bring the oil level to the
full mark on the dipstick.
Important
Overfilling the crankcase with oil may
cause engine damage.
Summary of Contents for 41165
Page 51: ...51...
