Toro 34215, Operator'S Manual

Page: 66 / 80

Controls System
Maintenance
Adjusting the Pattern
Control Cable for the
Spreader
1. Prepare the machine for maintenance; refer to
Preparing the Machine (page 50) .
2. Empty the hopper; refer to Emptying the
Spreader (page 26)
3. Close the impeller gate by pushing the
wide-distribution impeller-gate lever forward fully
(
Figure 85 ).
g027470
Figure 85
1. Unlock—spread pattern
control handle (rotate
counterclockwise) 3. Lock—spread pattern
control handle (rotate
clockwise)
2. Push down—spread
pattern control handle 4. Push
forward—wide-distribution
impeller-gate lever
4. Rotate the spread-pattern-control handle
counterclockwise, push the handle down,
and rotate the spread-pattern-control handle
clockwise(3) refer to
Figure 85 .
5. Loosen the jam nut at the end of the
pattern-control cable (
Figure 86 ).
g027205
Figure 86
1. Jam nut (pattern control cable)
2. Linkage rod
3. Impeller shaft
4. 1/8 inch (3.2 mm) gap between ramp tooth and impeller
shaft
5. Ramp tooth
6. Pull the linkage rod until there is 1/8 inch (3.2
mm) gap between the ramp tooth and the
impeller shaft (
Figure 86 ).
7. Tighten the jam nut ( Figure 86 ).
8. Adjust the spread-pattern-control handle; refer
to
Adjusting the Spreader Pattern (page 30) .
66