Toro 34215, Operator'S Manual

Page: 39 / 80

g027392
Figure 40
1. Strainer (sprayer tank) 2. Pump-shutoff valve
7. Start the engine and set the throttle midway
between the S
LOW
and F
AST
positions.
8. Set the sprayer-pump switch to the O
N
position
( Figure 41 ).
g033348
Figure 41
1. Sprayer-pressure control 5. Spray wand
2. Agitation-pump lever 6. Sprayer-pressure gauge
3. Narrow-spray pattern lever 7. Sprayer-pump/tank-agitation
switch
4. Wide-spray pattern lever 8. Sprayer-wand-pressure
control
9. Move the throttle to the F
AST
position.
10. Pull rearward on the tank-agitation lever to the
O
N
position.
Note:
The water in the tank will circulate.
11. Add the specified amount of chemical
concentrate to the tank as directed by the
chemical manufacturer.
Important:
If you are using a
wettable-powder chemical, mix the
powder with a small amount of water to form
a liquid slurry before adding the chemical
mixture to the tank.
12. Add remaining water to the tank and install cap
onto the filler neck of the tank.
Note:
Allow the content of the sprayer tank to
mix thoroughly.
Emptying the Sprayer Tank
Operator supplied equipment:
•
A drain hose with a 1/2–14 inch NPT male coupling
•
A drain container (capacity varies with remaining
sprayer tank content)
•
PTFE thread sealant
1. Move the machine to a level surface at the
designated area for emptying and cleaning the
sprayer tank, move motion-control lever to the
N
EUTRAL
position, shut off the engine, wait for all
moving parts to stop, remove key, and engage
parking brake.
2. Remove the plug from the drain valve for the
sprayer tank (
Figure 42 ).
Note:
The drain valve is located at the left side
of the machine.
g025542
Figure 42
1. Drain valve 2. Plug
3. Thread a drain hose (operator provided) into the
end of the drain valve.
4. Put the free end of the drain hose into a
container with enough capacity to hold the
remaining content of the sprayer tank.
39