Toro 34215, Operator'S Manual

Page: 63 / 80

Note:
Ensure that the negative battery cable
does not touch the battery terminal.
2. Push the tab on the fuse/relay holder and
separate the cover from the holder (
Figure 78 ).
3. Pull the fuse from the socket of the fuse/relay
holder (
Figure 78 ).
g027495
Figure 78
1. Battery box 3. Fuses
2. Cover 4. Fuse/relay holder
4. Install a fuse of the same type (20 A) into the
socket of the fuse/relay holder (
Figure 78 ).
5. Install the cover on to the fuse/relay holder until
it locks into place (
Figure 78 ).
6. Install the negative-battery cable from the battery
terminal; refer to steps
5 and 6 of Installing the
Battery (page 61) .
Drive System
Maintenance
Checking the Air Pressure
in the Tires
Service Interval: Every 50 hours
Note:
Service the air pressure in both the front and
rear tires.
1. Prepare the machine for maintenance; refer to
Preparing the Machine (page 50) .
2. Check tire pressure in front and rear tires.
3. If necessary, adjust the air pressure in the tires
to 83 to 97 kPa (12 to 14 psi).
Torquing the Axle Bolts
Service Interval: Yearly
1. Torque the 4 axle bolts on both front and rear
wheels (
Figure 79 ) to 48 N∙m (35 ft-lb).
2. Torque the 2 setscrews on each rear wheel to
12 N∙m (105 in-lb).
Important:
If you remove the wheel(s) for
maintenance, apply medium-grade thread-locking
compound to the threads of the bolts before
installing the wheel(s)
Important:
If you remove the rear wheel(s) for
maintenance apply a copper-based, anti-seizing
compound on the rear-axle shafts.
Important:
Do not use anti-seize compound on
the wheel bolts.
g033531
Figure 79
1. Axle bolts
2. Setscrews
63