1
Remove Side Deck Shipping
Strap and Brace
No Parts Required
Procedure
Remove the strap and brace securing the side decks for
shipping.
2
Lower Front Deck Winglets
Parts needed for this procedure:
1
Deck cover R.H.
1
Deck cover L.H.
2
V-Belt
Procedure
1. Remove the nuts securing the front and rear stop
bolts to the right winglet deck mounts (Figure 3).
2. While supporting the right winglet, remove the front
and rear stop bolts from the deck mounts (Figure 3).
Leave the eccentrics positioned between the deck
mounts.
3. Lower the winglet to the operating position.
Figure 3
1.
Winglet
4.
Eccentric
2.
Hinge pin
5.
Upper hole
3.
Stop bolt
6.
Deck mounts
4. Install the front and rear stop bolts through the
upper mounting holes and eccentrics. Make sure the
stop bolt engages the tab on the hinge pin.
5. Install the nuts securing the stop bolts but do not
tighten at this time.
6. Repeat the procedure on left winglet.
Figure 4
1.
Winglet
4.
Eccentric
2.
Hinge pin
5.
Lower hole
3.
Bolt
16
Summary of Contents for 31598
