Lubrication
Greasing the Bearings and
Bushings
Service Interval:
Before each use or daily—Lubricate
castor arm bushings.
Every 50 hours—Lubricate all grease
fittings.
The machine has grease fittings that must be lubricated
regularly with No. 2 General Purpose Lithium Base
Grease. If the machine is operated under normal
conditions, lubricate all bearings and bushings after
every 50 hours of operation or immediately after every
washing.
Note:
The castor fork shaft bushings must be
lubricated before each use or daily
The grease fitting locations and quantities are:
Traction Unit
•
Impact arms (2) (Figure 49)
•
Front Deck Lift cylinder pivots (2) (Figure 49)
•
Side Deck Lift cylinder pivots (2) (Figure 49)
•
Steering cylinder ball joints (4) (Figure 50)
•
Tie rod ball joints (2) (Figure 50)
•
King pin bushings (2) (Figure 50)
•
Rear axle pivot bushing (1) (Figure 51)
•
Brake shaft pivot bearings (1) (Figure 52)
Figure 49
43
Summary of Contents for 31598
