Toro 30643, Operator'S Manual

Page: 44 / 72

Lubrication
Greasing the Bearings and
Bushings
Service Interval: Every 50 hours
The machine has grease fittings that you must lubricate
regularly with No. 2 lithium grease. Also, lubricate the
machine immediately after every washing.
The grease-fitting locations and quantities are:
Traction Unit
•
2 brake pedal pivot-shaft bearings ( Figure 36 )
•
2 front and rear-axle-pivot bushings ( Figure 37 )
•
2 steering-cylinder-ball joints ( Figure 38 )
•
2 tie-rod-ball joints ( Figure 38 )
•
2 king-pin bushings ( Figure 38 ).
Note:
Lubricate only the top fitting on the king pin
annually (2 pumps).
Figure 36
Figure 37
Figure 38
Center Mower Deck
Note:
You may need to raise the deck to expose the grease
fittings for the latch pivot and the lower link.
•
2 latch pivots ( Figure 40 )
Note:
You may need to manually trip the latches to gain
access to the grease fittings ( Figure 39 ). Use a prybar to
close and open the latch.
•
2 castor-fork-shaft bushings ( Figure 41 )
•
3 spindle-shaft bearings—located under the pulley ( Figure
42 )
• 2 idler-arm-pivot bushings ( Figure 42 )
Figure 39
1. Latch
44