Toro 30643, Operator'S Manual

Page: 40 / 72

Maintenance
Note:
Determine the left and right sides of the machine from the normal operating position.
Recommended Maintenance Schedule(s)
Maintenance Service
Interval
Maintenance Procedure
After the first hour
• Torque the wheel-lug nuts.
After the first 10 hours
• Torque the wheel-lug nuts.
• Check the alternator-belt tension.
• Check the compressor belt tension.
• Check the blade-drive-belt tension.
After the first 200 hours
• Change the front planetary-gear oil.
• Change the rear-axle lubricant.
• Change the hydraulic filters.
Before each use or daily
• Check the tire pressure.
• Check the safety-interlock switches.
• Check the air-cleaner indicator
• Check the engine-oil level.
• Drain water or other contaminants from the water separator.
• Check the coolant level.
• Check the hydraulic-fluid level.
• Remove all debris and chaff from the engine compartment, radiator, and oil cooler.
Every 25 hours
• Check the electrolyte level (or every 30 days if the machine is in storage).
Every 50 hours
• Lubricate all bearings and bushings.
• Inspect the air cleaner.
• Check the condition of the battery.
• Check the blade-drive-belt tension.
Every 100 hours
• Inspect the cooling-system hoses and clamps.
• Check the alternator-belt tension.
• Check the compressor belt tension.
Every 200 hours
• Torque the wheel-lug nuts.
Every 250 hours
• Change the engine oil and filter.
• Clean the cab-air filters. (Replace them if they are torn or excessively dirty.)
• Clean the air-conditioning coil. (Clean more frequently in extremely dusty or dirty
conditions)
Every 400 hours
• Service the air cleaner (earlier if the air cleaner indicator shows red, and more
frequently in extremely dirty or dusty conditions).
• Inspect the fuel lines and connections.
• Replace the filter canister.
• Check the planetary-gear-drive oil (check if you notice external leakage).
• Check for end-play in the planetary drives.
• Check the rear-axle lubricant.
• Check the rear-axle-gearbox lubricant.
40