Toro 30487TC, Operator'S Manual

Page: 47 / 60

Controls System
Maintenance
Adjusting the Control-Lever
Neutral-Interlock Switch
1. Stop the machine, move the motion-control
levers to the N
EUTRAL
-
LOCK
position, engage the
parking brake, and remove the ignition key.
2. Remove the bolts securing the front panel and
remove the panel (
Figure 47 ).
g020875
Figure 47
1. Bolt
2. Control panel
3. Loosen the 2 screws securing the interlock
switch (
Figure 48 ).
g004763
Figure 48
1. Control lever 3. Screw
2. Neutral-interlock switch 4. 0.4 to 1 mm (0.015 to
0.045 inch)
4. Holding the control lever against the frame,
move the switch toward the lever until the
distance between the lever and switch body is
0.4 to 1 mm (0.015 to 0.045 inch) as shown in
Figure 48 .
5. Secure the switch.
6. Repeat steps 3 to 5 for the other lever.
7. Install the front panel.
Adjusting the Control-Lever
Neutral Return
If the motion-control levers do not align with the
neutral slots when released from the R
EVERSE
position, adjustment is required. Adjust each lever,
spring, and rod separately.
1. Disengage the PTO, move the control lever to
the N
EUTRAL
-
LOCK
position, and engage the
parking brake.
2. Move the throttle lever to the S
LOW
position,
shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Remove the bolts securing the front panel and
remove the panel (
Figure 49 ).
47