Toro 30487TC, Operator'S Manual

Page: 7 / 60

decal107-1866
107-1866
Note:
This machine complies with the industry standard
stability test in the static lateral and longitudinal tests with the
maximum recommended slope indicated on the decal. Review the
instructions for operating the machine on slopes in the
Operator’s
Manual as well as the conditions in which you would operate the
machine to determine whether you can operate the machine in the
conditions on that day and at that site. Changes in the terrain can
result in a change in slope operation for the machine. If possible,
keep the cutting units lowered to the ground while operating the
machine on slopes. Raising the cutting units while operating on
slopes can cause the machine to become unstable.
1. Sliding/loss of control hazard; tipping hazard, drop-offs—do
not turn at high speeds; turn at low speeds; do not use on
slopes near open water; do not use on slopes greater than
15°; stay away from drop-offs.
2. Warning—if the roll bar is lowered, do not wear the seatbelt;
if the roll bar is raised, wear the seatbelt.
3. Warning—do not use dual ramps when loading onto a
trailer; use 1 ramp wide enough for the machine; use a
ramp with a slope less than 15°.
decal107-3069
107-3069
1. Warning–there is no rollover protection when the roll bar is
down.
2. To avoid injury or death from a rollover accident, keep the
roll bar in the raised and locked position and wear the seat
belt. Lower the roll bar only when absolutely necessary; do
not wear the seat belt when the roll bar is down.
3. Read the Operator's Manual ; drive slowly and carefully.
7