Raising the Roll Bar
Raise the roll bar as shown in
g031624
g031631
Figure 11
Important:
Always use the seat belt when the
roll bar is in the raised and locked position. Do
not use the seat belt when the roll bar is in the
lowered position.
Using the Safety-Interlock
System
CAUTION
If the safety-interlock switches are
disconnected or damaged, the machine could
operate unexpectedly, causing personal
injury.
•
Do not tamper with the interlock switches.
•
Check the operation of the interlock
switches daily and replace any damaged
switches before operating the machine.
Understanding the
Safety-Interlock System
The safety-interlock system prevents the engine from
starting unless:
•
You are sitting on the seat or the parking brake
is engaged.
•
The power takeoff (PTO) is disengaged.
•
The motion-control levers are in the N
EUTRAL
-
LOCK
position.
•
The engine temperature is below the maximum
operating temperature.
The safety-interlock system also shuts off the
engine when you move the traction controls from
the N
EUTRAL
-
LOCK
position with the parking brake
engaged. If you rise from the seat when the PTO
is engaged, there is a 1-second delay and then the
engine shuts off.
Testing the Safety-Interlock
System
Service Interval:
Before each use or daily
Test the safety-interlock system before you use the
machine each time. If the safety system does not
operate as described below, have an Authorized
Service Dealer repair the safety system immediately.
1.
Sit on the seat, engage the parking brake, and
move the PTO to the O
N
position. Try starting
the engine; the engine should not crank.
2.
Sit on the seat, engage the parking brake,
and move the PTO to the O
FF
position.
Move either motion-control lever out of the
N
EUTRAL
-
LOCK
position. Try starting the engine;
the engine should not crank. Repeat for other
motion-control lever.
3.
Sit on the seat, engage the parking brake, move
the PTO switch to the O
FF
position, and move
the motion-control levers to the N
EUTRAL
-
LOCK
22
Summary of Contents for 30487TC
Page 11: ...decal127 6519 127 6519 1 Transport position 2 Height of cut 11...
Page 56: ...Notes...
Page 57: ...Notes...
