Figure 25
1. Center Gage Wheels and
Spacer
4. Washer
2. Nut
5. Spacer
3. Bolt
Adjusting the Handle Height
The handle position can be adjusted to match the
operator’s height preference.
1. Remove the hairpin cotter pins and clevis
pins from the drive levers and neutral locks
(Figure 26).
Figure 26
1. Control rod
5. Left handle shown
2. Clevis pin
6. Neutral lock
3. Drive lever
7. Hairpin cotter pin
4. Operator Presence Control
lever (OPC)
2. Loosen the nuts holding the swivel connected
to the speed control crank (Figure 27).
Figure 27
1. Speed control rod
3. Nut
2. Swivel
3. Loosen the upper flange bolts (3/8 x 1-1/4
inches) and flange nut securing handle to rear
frame (Figure 28).
4. Remove the lower flange bolts (3/8 x 1 inch)
and flange nuts securing handle to rear frame
(Figure 28).
5. Pivot handle to desired operating position and
install lower flange bolts (3/8 x 1 inch)and
flange nuts into mounting holes. Tighten all
flange bolts.
28
Summary of Contents for 30433
Page 7: ...Slope Chart 7...
Page 61: ...Schematics Hydraulic Schematic Rev A 61...
Page 62: ...Electrical Schematic Rev A 62...
