Step
1
Removing the Shipping
Bracket and Shipping
Washers
No Parts Required
Procedure
1. Remove the center gage wheel nut, 2 large
washers, angle bracket and 1 small washer
(Figure 2). Discard the 2 large washers and the
angle bracket.
Figure 2
1. Center Gage Wheels and
Spacer
4. Angle bracket-discard
2. Nut
5. Small washer
3. Large washer-discard
2. Install the center gage wheels with the
previously removed bolt, spacer, small washer,
and nut (Figure 3).
Figure 3
1. Center Gage Wheels and
Spacer
4. Washer
2. Nut
5. Spacer
3. Bolt
3. Remove the hairpin cotter and washer on both
front height-of-cut posts (Figure 4). Discard
the washers, these are not to be used for
adjusting the height-of-cut.
Figure 4
1. Hairpin cotter
3. Height-of-cut post
2. Shipping washer
4. Mower
12
Summary of Contents for 30433
Page 7: ...Slope Chart 7...
Page 61: ...Schematics Hydraulic Schematic Rev A 61...
Page 62: ...Electrical Schematic Rev A 62...
