Figure 73
1.
Flow control valve
Mower Maintenance
Pivoting (Tilting) the Front
Cutting Unit Upright
Note:
Although not needed for normal maintenance
procedures, the front cutting unit can be pivoted (tilted)
to an upright position. Should you desire to tilt the
cutting unit, proceed as follows:
1. Raise the center and wing cutting units slightly off of
the floor, set the parking brake, and stop the engine.
Remove the ignition key.
2. Remove the hairpin cotter securing dampers to lift
arms (Figure 74). Pivot damper toward deck housing.
Figure 74
1.
Damper
2.
Hair pin cotter
3. Remove the hairpin cotter and clevis pin securing
the height-of-cut chains to the rear of the cutting
unit (Figure 75).
Figure 75
1.
Height-of-cut chain
4. Start the engine and slowly raise the center cutting
unit.
5. Slowly raise each wing cutting until the center of
gravity shifts and the deck starts to rotate into the
upright position. Stop the engine and remove the
ignition key.
50
Summary of Contents for 30413
