Toro 30413, Operator'S Manual

Page: 43 / 64

level is up to the bottom of the planetary and brake
housing check holes. Capacity is approximately 16
oz. (0.5 l).
9. Install the plugs.
10. Repeat the procedure on the opposite gear assembly.
Figure 59
1. Brake housing 3. Check plug
2. Drain plug
Changing the Rear Axle
Lubricant
Service Interval: After the first 200 hours
Every 800 hours
Change the oil initially after the first 200 hours of
operation and every 800 hours of operation thereafter.
1. Position the machine on a level surface.
2. Clean the area around the 3 drain plugs; 1 on each
end and 1 in the center (Figure 60).
3. Remove the check plugs to ease in draining of the oil.
4. Remove the drain plugs and allow the oil to drain
into the pans.
Figure 60
1. Drain plug location
5. Clean the area around the drain plug on the bottom
of the gear box (Figure 61).
6. Remove the drain plug from the gear box and allow
the oil to drain into a pan. Remove the fill plug to
ease in draining of the oil.
Figure 61
1. Drain plug
7. Add enough oil to bring the level up to the bottom
of the check plug holes; refer to Checking the Rear
Axle Lubricant, and Checking the Rear Axle Gear
Box Lubricant.
8. Install the plugs.
43