Toro 30413, Operator'S Manual

Page: 14 / 64

Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure Description Qty. Use
1
No parts required
–
Grease the machine.
2
Warning Decal 1
Used only on machines requiring
European CE compliance.
Operator’s Manual 1
Engine Operator’s Manual 1
Parts Catalog 1
Operator Training Materials 1
Pre-delivery Inspection Sheet 1
3
Declaration of conformity 1
Read the manuals and training materials
before operating the machine. Use the
remaining parts for the installation of
attachments.
Note:
Determine the left and right sides of the machine
from the normal operating position.
1
Greasing the Machine
No Parts Required
Procedure
Before the machine is operated, it must be greased
to ensure proper lubricating characteristics; refer to
Greasing the Bearings and Bushings procedure of
Lubrication , page 33. Failure to properly grease the
machine will result in premature failure of critical parts.
2
Replacing the Warning Decal
Parts needed for this procedure:
1 Warning Decal
Procedure
On machines requiring European CE compliance,
replace the warning decal, part no. 114–5605 with the
warning decal part no. 114–5604.
3
Reading the Manuals and
Review the Training Materials
Parts needed for this procedure:
1 Operator’s Manual
1 Engine Operator’s Manual
1 Parts Catalog
1 Operator Training Materials
1 Pre-delivery Inspection Sheet
1 Declaration of conformity
Procedure
1. Read the manuals.
2. View the Operator Training materials
14