Toro 30413, Operator'S Manual

Page: 38 / 64

Important:
Never attempt to clean the safety
filter (Figure 49). Replace the safety filter with a
new one after every three primary filter services.
Figure 49
1. Air cleaner safety filter
4. Clean the dirt ejection port located in the removable
cover. Remove the rubber outlet valve from the
cover, clean the cavity and replace the outlet valve.
5. Install the cover orienting the rubber outlet valve in
a downward position - between approximately 5:00
to 7:00 when viewed from the end.
6. Reset the indicator (Figure 47) if it shows red.
Servicing the Engine Oil and
Filter
Service Interval: After the first 50 hours
Every 150 hours
Change the oil and filter initially after the first 50 hours
of operation; thereafter change the oil and filter every
150 hours.
1. Remove either drain plug (Figure 50) and let the oil
flow into a drain pan. When the oil stops, install the
drain plug.
Figure 50
1. Engine oil drain plug
2. Remove the oil filter (Figure 51). Apply a light coat
of clean oil to the new filter seal before screwing it
on.
Do not overtighten.
Figure 51
1. Engine oil filter
3. Add oil to the crankcase; refer to Checking the
Engine Oil.
38