Toro 30413, Operator'S Manual

Page: 17 / 64

Hour Meter
The hour meter (Figure 4) shows the total hours that the
machine has been operated.
Temperature Override Switch
Press and hold the reset switch (Figure 4) to start the
engine after high temperature shut down. Use only for
emergency operation.
Audible Alarm
The alarm (Figure 4) is activated when the low engine
oil pressure light illuminates or the high coolant
temperature light illuminates.
Alarm Silence Switch
This switch (Figure 4) shuts off the audible alarm.
Throttle Control
Move the control (Figure 4) forward to increase the
engine speed and rearward to decrease the speed.
Power Point
The power point (Figure 4) is used to power optional
electrical accessories.
Engine Cooling Fan Switch
The machine is equipped with a hydraulically driven auto
reversing engine cooling fan. The fan switch (Figure 4)
has three positions R (manual reverse), Auto (normal)
and F (forward only). Refer to Engine Cooling Fan
Operation in the Operation Section of manual
Specifications
Note:
Specifications and design are subject to change without notice.
Width of cut
overall 124 inch (315 cm)
front cutting unit 54 inch (137 cm)
side cutting unit 37 inch (94 cm)
front and one side cutting unit 89 inch (226 cm)
Overall width
cutting units down 127 inch (322 cm)
cutting units up (transports) 71 inch (180 cm)
Overall length 144 inch (366 cm)
Height
58 inch (147 cm)
Height with ROPS 81 inch (206 cm)
Ground clearance 6 inch (15 cm)
Wheel tread (to center of tire)
front 45 inch (114 cm)
rear
47 inch (119 cm)
Wheel base 55-1/2 inch (141 cm)
Weight (with cutting units and fluids) 4211 lb (1910 kg)
Attachments/Accessories
A selection of Toro approved attachments and
accessories are available for use with the machine to
enhance and expand its capabilities. Contact your
Authorized Service Dealer or Distributor or go to
www.Toro.com for a list of all approved attachments
and accessories.
17