Toro 30069, Operator'S Manual

Page: 22 / 52

Maintenance
Note:
Determine the left and right sides of the machine from the normal operating position.
Recommended Maintenance Schedule(s)
Maintenance Service
Interval
Maintenance Procedure
After the first 8 hours
• Change the engine oil.
• Check the mower belt tension.
• Check the hydraulic fluid level.
• Replace the hydraulic oil filter.
After the first 25 hours
• Check the mower belt tension.
Before each use or daily
• Check the safety system.
• Grease the caster wheels and caster pivot.
• Check the engine oil level.
• Clean the air intake screen.
• Inspect the blades.
• Clean the mower deck.
Every 25 hours
• Clean foam air cleaner element.
• Check the hydraulic fluid level.
Every 50 hours
• Grease the mower belt idler.
• Grease the pump drive idler pivot.
• Grease the pump control.
• Check the paper air cleaner element.
• Check the tyre pressure.
• Check the belts.
• Check the mower belt tension.
Every 100 hours
• Grease the blade engagement bellcrank.
• Change the engine oil.
• Check the spark plugs.
• Check hydraulic lines and hoses.
Every 200 hours
• Replace the paper air cleaner element.
• Change the oil filter.
• Replace the fuel filter.
• Replace the hydraulic oil filter.
Every 400 hours
• Lubricate the cam lock with Never-Seez®.
Before storage
• Paint chipped surfaces.
• Perform all maintenance procedures listed above before storage.
Important:
Refer to your engine operator's manual for additional maintenance procedures.
CAUTION
If you leave the key in the ignition switch, someone could accidently start the engine and seriously injure
you or other bystanders.
Remove the key from the ignition and disconnect the spark plug wire from the spark plug(s) before you do
any maintenance. Set the wire aside so that it does not accidentally contact the spark plug.
Lubrication
Use Figure 20 for locating the grease points on the
machine.
Grease with No. 2 general purpose lithium base or
molybdenum base grease.
22