Toro 30069, Operator'S Manual

Page: 20 / 52

Adjusting the Handle Height
The handle position can be adjusted to match the
operator's height preference.
1. Remove the hairpin cotter pins and clevis pins from
the drive levers and neutral locks (Figure 18).
Figure 18
1. Control rod 5. Left handle shown
2. Clevis pin 6. Neutral lock
3. Drive lever 7. Hairpin cotter pin
4. Operator Presence
Control lever (OPC)
2. Loosen the upper flange bolts (3/8 x 1-1/4 inch)
and flange nut securing handle to rear frame
(Figure 19).
3. Remove the lower flange bolts (3/8 x 1 inch)
and flange nuts securing handle to rear frame
(Figure 19).
4. Pivot handle to desired operating position and
install lower flange bolts (3/8 x 1 inch)and flange
nuts into mounting holes. Tighten all flange bolts.
Figure 19
1. Control rod fitting 6. High position
2. Lower mounting holes 7. Lower position
3. Rear frame 8. Upper mounting hole
4. Lower flange bolt (3/8 x 1
inch) 9. Handle
5. Upper flange bolt (3/8 x
1-1/4 inches) 10. Flange nut (3/8 inch)
5. Adjust the control rod length by rotating the control
rod in the rod fitting (Figure 18 and Figure 19).
6. Install hairpin cotter between drive levers and
neutral locks and into clevis pins (Figure 18).
Note:
Make sure the clevis pins are inserted into
the neutral locks.
7. Perform the hydraulic linkage adjustments when the
handle height is changed; refer Hydraulic Linkage
Adjustments.
20