Toro 2226, Operator'S Manual

Page: 92 / 108

Changing the Hydraulic-Fluid
Return Filter
Service Interval: Every 800 hours/Every 6 months
(whichever comes first)
1. Move the machine to a level surface, shut off
the engine, and remove the key.
2. Discard the old hydraulic-fluid return filter.
g229101
Figure 113
3. Install a new hydraulic-fluid return filter.
Changing the Hydraulic-Charge
Filter
Service Interval: Every 800 hours/Every 6 months
(whichever comes first)
1. Move the machine to a level surface, shut off
the engine, and remove the key.
2. Open the front hood.
3. Place a drain pan under the filter.
4. Using a filter wrench, remove the
hydraulic-charge filter (
Figure 114 ).
g229100
Figure 114
5. Discard the old filter.
6. Apply a thin layer of hydraulic oil to the o-ring
of the filter.
7. Install and tighten the new filter with a filter
wrench.
8. Start the engine, let it run idle for approximately
1 minute, then check for leaks around the
hydraulic-charge filter.
92