Toro 2226, Operator'S Manual

Page: 81 / 108

g234645
Figure 98
1. Jumper-cable post
(negative) 2. Jumper-cable post
(positive)
7. Connect the positive (+) jumper cable to the
jump post (
Figure 98 ).
8. Connect the negative (-) jumper cable to a
ground point, such as an unpainted bolt or
chassis member (
Figure 98 ).
9. Start the engine; refer to Starting and Shutting
Off the Engine (page 47) .
Important:
If the engine starts and then
stops, do not operate the starter motor until
the starter motor stops turning. Do not
operate the starter motor for more than 30
seconds at a time. Wait 30 seconds before
operating the starter motor to cool the motor
and to build up the charge in the battery.
10. When the engine starts, have the other person
disconnect the negative (-) jumper cable from
the frame and then disconnect the positive (+)
jumper cable (
Figure 98 ).
Drive System
Maintenance
Checking the Planetary
Drive Oil Level Planetary
Drive
Service Interval: Every 50 hours—Check the
planetary-drive oil level (Also, check
if external leakage is observed).
Oil specification: SAE 85W-140 API classification
level GL4
Planetary drive oil capacity: approximately 1.4 L
(1.5 US qt)
Toro Premium Gear Oil is available from an Authorized
Service Dealer. See the
Parts Catalog for part
numbers.
1. Move the machine to a level surface, shut off
the engine, and remove the key.
2. Clean the area around the oil-level plug with a
cleaning solvent (
Figure 99 ).
g021828
Figure 99
1. Oil-level plug 2. Oil-drain plug (6 o’clock
position)
3. Rotate the planetary drive until the oil level and
the oil-drain plugs are vertical to the ground (at
the 6 o’clock position) as shown in
Figure 99 .
4. Remove the oil-level plug ( Figure 99 ).
Note:
The oil level is correct when it is up to the
bottom of the oil-level plug hole.
5. If the oil is below the bottom of the hole, add the
specified oil until the oil is level with the bottom
of the hole.
6. Install and tighten the oil-level plug.
81