Toro 147-1660, Manual

Page: 13 / 52

SUPERCEDED
12
Checking the Mower Deck
Height of Cut and Rake
No Parts Required
Procedure
Refer to the Adjusting the Side-to-Side Leveling and
the Blade Slope procedure in the
Operator's Manual .
Operation
Adjusting the Height of Cut
For Machines with an Electric
Deck Lift
1. Push up on the deck-lift switch ( Figure 21 ).
g332765
Figure 21
1. Push up to raise the deck. 2. Push down to lower the
deck.
2. Select a hole in the height-of-cut bracket
corresponding to the height of cut desired, and
insert the pin (
Figure 22 ).
3. Push down on the deck-lift switch until the
height-of-cut linkage slightly contacts the
height-of-cut pin (
Figure 22 ).
Note:
Too much contact between the
height-of-cut linkage and height-of-cut pin can
negatively affect the mower deck height of cut
and leveling.
g361935
Figure 22
1. Height-of-cut pin 3. Height-of-cut bracket
2. Height-of-cut linkage
11