Toro 137-1019, Installation Instructions Manual

Page: 15 / 24

Ensure that you install the seal with longer lip
to the front (
Figure 46 ).
g246051
Figure 46
1. Lower dash seal 2. Longer lip to the front
5. Hold the cab frame using the lifting points and
place it on the machine (
Figure 47 ).
Note:
Before lowering the cab on to the
machine, apply soapy water to the dash to keep
the lower dash seal lubricated.
Note:
Ensure that the front and rear lips on the
lower dash seal do roll under during installation.
g026247
Figure 47
1. Lifting points
6. Secure the frame to the machine using the 4
bolts (1/2 inch), 4 washers (1/2 inch), and 4 nuts
(1/2 inch) as shown in
Figure 48 .
Note:
Do not tighten the 4 bolts (1/2 inch).
g026272
Figure 48
7. Adjust the cab from side to side to ensure that
the cab is centered.
Use the adjuster bolt ( Figure 42 ) to center the
cab.
8. Torque the 4 bolts (1/2 inch) to 91 to 113 N∙m
(67 to 83 ft-lb).
13
Routing the Wire Harness
Parts needed for this procedure:
1 Wire harness
4 Cable ties
1 Fuse (30 A)
Procedure
1. Route the wire harness as shown in Figure 49
and secure it with the 4 cable ties.
15