Figure 6
1.
Frame channel
3.
Kit hose
2.
Floor-channel plate
5.
Route the kit hose through the opening in the top of
the frame channel (
).
Figure 7
1.
Frame channel
2.
Kit hose
6.
Secure the kit hose along the frame channel and as
necessary.
7.
Connect the kit to the pump; refer to
Hose to the Pump (page 4)
.
Connecting the Hose to the Pump
1.
At the washer-fluid tank, align the end of the hose to
the barbed fitting in the washer pump (
).
Figure 8
1.
Hose
3.
Washer-pump motor
2.
Barbed fitting
2.
Push the hose onto the fitting until the hose fully seats
onto the fitting (
).
Note:
If the hose is too long, shorten it.
Routing and Connecting the Kit Wire
Harness to the Cab Wire Harness
1.
Connect the male connector on the kit wire harness to
the female connector on the cab wire harness (
).
Figure 9
1.
Cab wire harness
3.
Male connector
2.
Female connector
4.
Kit wire harness
2.
Route the kit wire harness along the floor-channel plate
and through the opening in frame channel (
).
4
