Toro 130-5615, Installation Instructions Manual

Page: 11 / 20

Securing the Wire Harness and Hose
1. Remove the 2 harness clips that secure the cab wire
harness to the front, left cab frame (
Figure 30 ).
Figure 30
1. Push fasteners
3. Bulb seal
2. Harness clips
2. Install 2 push fasteners at the location where you
removed the harness clips in step
1 ( Figure 30 and
Figure 31 ).
Figure 31
1. Hole (seal mount) 2. Push fasteners
3. Secure the cab harness, washer-pump harness, and
hose with the cable tie portion of the push fasteners
(
Figure 31 ).
Note:
Tighten the cable tie only snug. Do not pinch
or collapse the hose.
4. Remove the 3 push fasteners above the driver’s door
frame (
Figure 30 ).
5. Install 3 push fasteners at the location where you
removed the push fasteners in step
4 ( Figure 30 and
Figure 31 ).
6. Secure the washer-pump harness and hose with the
cable-tie portion of the push fasteners.
7. At the back of the cab, install 3 push fasteners into the
3 hole across the back panel of the cab (
Figure 32 ).
Figure 32
1. Hole (back cab panel) 2. Push fasteners
8. Secure the washer-pump harness and hose with the
cable tie portion of the push fasteners.
9. If needed, shorten the hose as follows:
A. At the washer fluid tank, remove the hose from
the barbed fitting at the pump (
Figure 24 ).
B. Cut the hose to remove the excess hose length.
C. Push the hose onto the fitting until the hose fully
seats onto the fitting (
Figure 24 ).
Installing the Overhead Console Plug
and the Roof Panel
1. Align the plug that you removed in step 3 of Removing
the Roof Panel (page 6) with the top opening of the
overhead console ( Figure 14 ).
2. Push the plug down into the overhead console until it
is seated (
Figure 14 ).
3. Align the holes in the roof panel with the clip nuts at
the brackets of the cab frame (
Figure 13 ).
4. Assemble the roof panel to the cab frame with the 10
bolts (1/4 x 1 inch) and 10 sealing washers (1/4 inch)
as shown in
Figure 13 that you removed in step 1 of
Removing the Roof Panel (page 6) .
5. Torque the bolts to 520 to 678 N∙cm (41 to 55 in-lb).
Connecting the Battery
1. Connect the negative-battery cable; refer to your
Operator’s Manual .
2. Lower the cargo box; refer to your Operator’s Manual .
11