Toro 130-5615, Installation Instructions Manual

Page: 17 / 20

Securing the Wire Harness
1. Remove the 2 harness clips that secure the cab wire
harness to the front, left cab frame (
Figure 48 ).
Figure 48
1. Harness clips 2. Cab frame
2. Install 2 push fasteners at the location where you
removed the harness clips in step
1 ( Figure 48 and
Figure 49 ).
Figure 49
1. Push fastener 2. Hole (cab frame)
3. Secure the cab harness, washer-pump harness, and
hose with the cable tie portion of the push fasteners
(
Figure 49 ).
Note:
Tighten the cable tie only snug. Do not pinch
or collapse the hose.
4. Remove the harness clip that secures the cab wire
harness to the lower forward-cab panel at the driver’s
side of the machine (
Figure 50 ).
Figure 50
1. Harness clip 4. Wire harnesses (cab
harness and washer-pump
harness)
2. Hose
5. Push fastener
3. Hole (lower, forward cab
panel)
5. Install a push fastener at the location where you
removed the harness clip in step
4 ( Figure 50 ).
6. Secure the cab harness, washer-pump harness, and
hose with the cable tie portion of the push fastener
(
Figure 50 ).
7. Coil the excess washer-pump harness ( Figure 51 ), and
secure the coiled harness and hose with a cable tie.
Figure 51
1. Electrical mounting plate 4. Washer-pump harness
(coiled)
2. Hose 5. Fender
3. Cable tie
17