Toro 130-5615, Installation Instructions Manual

Page: 9 / 20

Connecting the Hose to the Pump
1. At the washer-fluid tank, align the end of the hose to
the barbed fitting in the washer pump (
Figure 24 ).
Figure 24
1. Washer-pump motor 3. Hose
2. Barbed fitting
2. Push the hose onto the fitting until the hose fully seats
onto the fitting (
Figure 24 ).
Note:
If the hose is too long, shorten it in step 9 of
Securing the Wire Harness and Hose (page 11) .
Connecting the Wire Harness at the
Overhead Console
1. At the overhead console, route the 2-pin connector
end of the wire harness for the washer pump through
the hole in the overhead console (
Figure 25 ).
Figure 25
1. Hole (overhead console) 3. Washer pump wire
harness
2. 2-socket connector (cab
wire harness) 4. 2-pin connector (washer
pump wire harness)
2. Align the 2-pin connector of the washer pump wire
harness to the 2-socket connector of the cab wire
harness (
Figure 25 ).
3. Push the 2 connectors together until the connector
lock snaps secure (
Figure 25 ).
4. Route the 2-socket connector of the wire harness for
the washer pump to the left of the overhead console
along the bulb seal at the front of the cab frame (
Figure
25 ).
9