Toro 08731, Operator'S Manual

Page: 2 / 16

Procedure Description Qty. Use
Lever assembly 1
Bolt (5/16 x 2 inches) 1
Locknut (5/16 inch) 3
Pivot tab 1
Toolbar link 1
Carriage bolt (3/8 x 1-1/4 inches)
1
Spacer 1
Washer (1 inch) 1
Locknut (3/8 inch) 1
Pedal lever assembly 1
Retaining ring 2
Washer (7/8 inch)
1
Bolt (5/16 x 1 inch) 1
7
Eccentric bolt 1
Install the toolbar lift pedal.
8
No parts required
–
Adjust the pivot spring tension and the
adjustable rod assembly.
9
No parts required
–
Adjust the toolbar transport height.
Shim (Part no. 110-7379) 1
Shim (Part no. 110-7380) 1
10
Shim (Part no. 110-7381) 1
Level the toolbar.
11
No parts required
–
Read/store the documentation.
1
Doing the Pre-Installation
Setup
No Parts Required
Procedure
Note:
If you will be installing the spring tine toolbar, install
the pivot tube brackets supplied with the spring tine toolbar
instead of the ones supplied with this attachment. Refer to the
Spring Tine Toolbar Installation Instructions for more information.
Note:
When installing a front manual blade in conjunction
with a midmount toolbar system, install the midmount
toolbar system first.
2
Installing the Scarifier
Lift-handle Assembly
Parts needed for this procedure:
2 Bolt (5/16 x 2-1/4 inches)
2 Nut (5/16 inch)
1 Scarifier lift-handle assembly
2 Bolt (1/2 x 3-1/4 inches)
2 Thin locknut (1/2 inch)
1 Detent plate
1 Knob
Procedure
1. Block up the rear of the machine and remove the rear
tires.
Note:
Place the blocks under the rear wheel motor
mounts.
2. Remove the 4 flange-head screws that secure the
right-hand wheel shroud to the frame (Figure 1).
2