Step 5; See Figure 5:
Install the right and left Front Post (3 & 4)
A.
Place the right Front Post into position as
shown.
B.
Insert a 5/16” x 1” bolt with flat washer inwards
through the slotted tab at Reference B, the dash
and then the Dash Support Bracket into the clip
nut. Do not tighten at this time.
C.
Insert a 5/16” x 3/4” bolt down through the tab
welded to the bottom of the post and the
floorboard. Add a 5/16” flange lock nut. Do not
tighten at this time.
D.
Repeat the above steps on the other side. use a
5/16” locknut on the bolt at Reference B.
Figure 5
Step 6; See Figure 6:
Install the left and right Top Frames (5 & 6).
A.
Place the ends of the top frames into the ends
of the front and rear posts.
B
5
IMPORTANT !
The two thru-holes near the bend of the part
should be at the rear of the top frame and
the single tapped hole
must
be to the inside
of the frame.
3
Figure 6
7
