WARNING
1. This cab is designed to provide foul weather protection only. It does not provide protection
from noise, exhaust fumes, chemicals or injury from collision, or other accidents.
2. Do not operate the machine in confined areas without proper ventilation.
3. Thoroughly check area of operation before using the machine.
MAINTENANCE INSTRUCTIONS
Periodically check all bolts to see that they are tight. If bolts become loose, failure of cab parts may occur.
DO NOT CLEAN THE CLEAR PLASTIC WINDOWS WHEN THE PLASTIC IS DRY.
THE CLEAR PLASTIC WILL SCRATCH.
Avoid contact with plastic windows. Keep plastic windows clean by washing them with clear running water
and rubbing with your bare hands, only. The use of a rag, sponge or brush will scratch the plastic. Liquid
soap may also be used for window cleaning. During freezing weather, an automotive windshield washer
solvent may be used.
Use liquid soap and water to clean colored vinyl portions. Scrubbing with a brush or rag is also permitted
on the colored vinyl portions
STORAGE INSTRUCTIONS
Prior to storage clean the windows and colored vinyl parts with a mild automotive detergent, rinse with
clean water and allow to thoroughly dry, Store cab in a clean dry place out of direct sunlight. Avoid folding
plastic windows.
INSTALLATION
READ THIS MANUAL COMPLETELY BEFORE BEGINNING INSTALLATION.
•
The right side of the machine is determined from the operator position.
•
Do not tighten bolts during assembly unless instructed to do so.
•
Park machine on level ground, set parking brake, remove start key.
•
The words "bolt" will refer to a 1/4”x 5/8” bolt and "lock nut"’ will refer to a 1/4” lock nut unless
specified otherwise.
•
Some of the steps will require two persons to complete.
2
