Step 2; See Figure 2A, 2B, 2C & 2D:
Figure 2A
Install fuel tank vent hose.
A.
Remove the knob from the gearshift. Remove the
four screws that hold the shifter plate to the shifter
bracket. Remove the four screws that hold the shifter
plate to the seat base. Remove the shifter plate.
B.
Remove the cotter pins and clevis pins that secure
the parking cables to the rear wheel brake levers.
Remove the R clamps and C clips holding the brake
cable to the frame.
C.
Remove the seats from the seat base. Remove the
8 flange screws securing the seat base to the floor plate
and front frame. Remove the seat base.
Figure 2B
D.
Install the fuel tank vent extension fitting and hose
as shown below.
NOTE:
Installation of this enclosure on
any MDE electric unit and 2010 & up
gasoline models does not require Step 2.
WARNING !
The following procedure to vent the fuel
tank is required to prevent the build up of
gasoline fumes inside the cab. Gasoline
fumes can ignite causing serious injury or
death.
Figure 2D
E.
Reverse steps 2 A B & C to replace the seat and
seat base
Figure 2C
5
