Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
Description
Qty.
Use
1
No parts required
–
Requirements before using the vehicle.
2
No parts required
–
Remove the tongue and hydraulic
cylinder from the shipping position.
Hitch tongue
1
Hitch pin
1
Bolt (3/8 x 1-1/4 inch)
1
Nut (3/8-16)
1
Large washer
1
Large nut
1
3
Square-head set screw
1
Install the hitch tongue
Rear-actuator tab
1
Bolt (1/2 x 2 inch)
4
Flat washer (.531 x .063)
8
Locknut (1/2 inch)
4
Bolt (3/8 x 1–1/4 inch)
2
Pin assembly
2
4
Flange nut (3/8 inch)
2
Install the hydraulic cylinder.
Power wiring harness
1
5
Cable tie
2
Install the power wiring harness.
Hitch pin
1
6
Hairpin cotter
1
Mount the sweeper to the tow vehicle.
7
Cable tie
8
Route and secure the hydraulic hoses
and wiring harness.
8
No parts required
–
Connect the hydraulic hoses.
9
No parts required
–
Connect the harness.
Blade-mounting assembly
1
Bolt (7/16 x 3-3/4 inch)
1
Bolt (7/16 x 3-1/4 inch)
1
Small washer (1/2 inch)
4
Large washer
1
Spacer
1
Locknut (7/16 inch)
2
Chain
1
Bolt (3/8 x 1-1/4 inch)
1
Flange nut (3/8 inch)
1
10
Snap link
1
Mount the windrow blades.
Handheld remote
1
Battery (AAA)
4
11
Screws, small
6
Assemble the handheld remote.
8
Summary of Contents for 07068
Page 34: ...Notes 34...
