Toro 07068, Operator'S Manual

Page: 13 / 36

Figure 9
1. Hitch pin 3. Hairpin cotter
2. Clevis
•
Raise or lower the hitch clevis to the position
approximately level with the tow vehicle hitch.
•
Secure the clevis to the hitch with the bolts and
locknuts previously removed.
Note:
Make sure that the sweeper is parallel with
the ground.
6. Connect the sweeper clevis hitch to the tow vehicle
hitch with the hitch pin and hairpin cotter.
7. Remove the spring pin, rotate the jack and up to the
storage position and install the spring pin.
7
Routing and Securing the
Hydraulic Hoses and Wiring
Harness
Parts needed for this procedure:
8 Cable tie
Procedure
1. Route the hydraulic hoses and wiring harness through
the hose guides to the front of the hitch tongue (
Figure
10 ).
Figure 10
1. Hydraulic hoses and wiring
harness 2. Hose guide
2. Secure the hydraulic hoses and wiring harness as shown
in
Figure 11 and Figure 12 .
Figure 11
Front View
1. Cable tie (6)
Figure 12
Rear View
1. Cable tie (2)
13