3
Specifications
General Specifications
Tractors
These cutting units will mount on the Greensmaster 3000, Greensmaster 3000–D,
Greensmaster 3050, Greensmaster 3100, Greensmaster 3150, and
Greensmaster 3250–D.
Height of Cut
Cutting height is adjusted on the front roller by two vertical screws and held by two
locking capscrews.
Height Of Cut Range
Standard bench height of cut range is .062 inch (1.6 mm) to .375 inches (9.5 mm).
Bench height of cut range with the High Height of Cut Kit installed is .285 inch
(7 mm) to 1 inch (25 mm). Effective HOC may vary depending on turf conditions,
type of bedknife, rollers and attachments installed.
Reel Weldment
Reels are 5 inches (13 cm.) in diameter, 21 inches (53.3 cm.) in length. High
strength low alloy steel blades are thru hardened and impact resistant.
Reel Bearings
Two double row self–aligning ball bearings, 30 +/–.1 mm inside diameter slip fit
onto reel shaft with lock nut. Additional inboard and outboard seals for added
protection. Reel position maintained by a wave washer with no adjusting nut.
Reel Drive
The reel weldment shaft is a 1.375 inch diameter tube with drive inserts
permanently pressed in both ends. A replaceable floating coupler with an internal
eight tooth spline is factory installed on the right end, and held in place by a snap
ring. The floating coupler may be moved to the other end when the cutting unit is
used on the Greensmaster 3250–D right front position.
Frame
Die cast aluminum cross member with two bolt–on die–cast aluminum side plates.
Rear Roller
Steel full, 2 inch (5.1 cm.) diameter with sealed bearings and through–shaft. The
rear roller has two positions, allowing user to change the cutting unit attitude and
the behind center distance of bedknife from reel center line.
Bedknife
Replaceable single edged, high carbon steel bedknife is fastened to a machined
cast iron bedbar with 13 screws. Tournament bedknife is standard.
Bedknife Adjustment
Dual screw adjustment to the reel; detents corresponding to .0007 inch (.018 mm)
bedknife movement for each indexed position.
Grass Shield
Non–adjustable shield with adjustable cut–off bar to improve grass discharge from
reel in wet conditions.
Counterweight
A cast iron weight mounted opposite to the drive motor balances the cutting unit.
Maximum Reel Speed
2200 RPM.
Weight
8 Blade
72 lb. (32 kg)
11 Blade 75 lb. (34 kg)
