Toro 03763, Installation Instructions Manual

Page: 8 / 24

4. On the idler assembly side, align the
adjuster-arm rod of the HOC bracket with the
adjuster collar on the idler assembly and secure
it with a shoulder bolt as shown in
Figure 12 ;
torque the shoulder bolt to 20 to 26 N
⋅
m (15 to
19 ft-lb).
g346925
Figure 12
1. Shoulder bolt 3. Adjuster collar
2. Adjuster-arm rod 4. Idler assembly
5. Tighten the carriage bolts and locknuts securing
the HOC bracket assemblies to the side plates
(
Figure 13 ).
g346926
Figure 13
1. Adjusting bolt 4. Flange nut
2. Locknut 5. Capscrew
3. Carriage bolt and flange
locknut (3/8 with 5/8 inch
hex)
6. Tighten the locknut on the HOC adjuster bolt,
then back off the locknut 1/2 turn (
Figure 13 ).
7. Center the front roller between the HOC bracket
assemblies and lock it in place with the cap
screws and flange nuts (
Figure 13 ).
8
Installing the Groomer
Drive Cap
Parts needed for this procedure:
5 Cap
Procedure
Only for Universal Groomer assemblies with no
rear roller brush kit installed:
1. Apply medium-strength cylindrical bonding
retaining compound (such as Green Loctite
609®) around the snap ring groove and the
outer diameter surface (
Figure 14 ).
8