Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Description
Qty.
Use
45 degree grease fitting
1
Height of cut bracket assembly, R.H.
1
Height of cut bracket assembly, L.H.
1
Flange lock nut, 3/8 inch
2
Splined insert
1
Groomer shaft assembly
1
Shim washer (as required for belt alignment)
1
Socket head screws, 3/8 x 1 inch
4
Groomer belt
1
Idler spring
1
Rubber grommet ring (used only if rear roller
brush kit is installed)
1
Set screw (used only if rear roller brush kit is
installed)
1
Operator’s Manual
1
Parts Catalog
1
Install the Groomer
No parts required
–
Install the Broomer Kit (optional)
Traction Unit Requirements
The Right and Left Groomer Kit Models 03713 and 03714
can be used on Reelmaster 7000-D DPA Cutting Unit Models
03710 and 03711 with or without a Rear Roller Brush Kit.
Note:
Determine the left and right sides of the machine
from the normal operating position.
Tools Required for Setup
•
5/16 socket
•
1/2 deep–well socket
•
9/16 deep-well socket
•
5/8 socket
•
3/8 wrench
•
1/2 wrench
•
9/16 wrench (2)
•
5/16 Allen wrench
•
5/32 mm Allen wrench
•
3/8-16 tap
•
Needle nose pliers
•
6 inch ruler, Toro Part No. 114–5446
•
12 inch straight edge
•
Flat screw driver
•
Vise clamp pliers
•
Torque wrench 15-19 ft-lb (20-26 N-m)
•
Torque wrench 27-33 ft-lb (36-45 N-m)
•
Torque wrench 34-40 ft-lb (46-54 N-m)
•
Torque wrench 85-95 ft-lb (115-129 N-m)
•
Reel drive shaft tool, Part No. TOR4074
•
Blue 242 Loctite
5
