Figure 24
1.
Groomer shaft assembly
7.
Shim (must remain loose after installation)
2.
Groomer plate w/quick-up lever (non-drive end)
8.
Pivot hub (non-drive end)
3.
Pivot hub (drive end)
9.
Idler spring
4.
Splined shaft
10.
Belt
5.
Groomer plate w/quick-up lever (drive end)
11.
Seal spring
6.
Quick-up lever
25.
Secure the non-drive pivot hub to the cutting unit side
plate with (2) 3/8 x 1 inch screws (
). Apply
blue Loctite to the screw threads prior to installation.
26.
Make sure the seal lip on each excluder seal, is in light
contact with each bearing housing (
).
Figure 25
1.
Excluder seal
2.
Bearing housing
27.
Mount the quick-up lever assemblies to the side plates
with 3/8 x 3/4 inch flange head bolts (
).
28.
Install the groomer belt onto the pulleys (
Make sure the ribs on the belt are properly seated in
the grooves on each pulley.
29.
Hook the idler spring in the hole in the idler plate tab
and around the groove on the groomer plate lower stud
(
). The open end of the spring hook is to be
positioned toward the drive pulley.
13
