Important:
Make sure the pivot hub mounting
surface is flush with the side plate on the cutting
unit. The shim must not be pinched between the
pivot hub and the side plate.
17.
Install the non-drive groomer plate onto the groomer
shaft (
). Be careful not to knock the seal spring
off.
18.
Secure the non-drive pivot hub to the cutting unit side
plate with (2) 3/8 x 1 inch socket head screws (
). Apply blue Loctite to the screw threads prior to
installation.
Figure 9
1.
Groomer shaft assembly
7.
Shim (must remain loose after installation)
2.
Groomer plate w/quick-up lever (non-drive end)
8.
Pivot hub (non-drive end)
3.
Pivot hub (drive end)
9.
Idler spring
4.
Splined shaft
10.
Belt
5.
Groomer plate w/quick-up lever (drive end)
11.
Seal spring
6.
Quick -up lever
19.
Make sure the seal lip on each excluder seal, is in light
contact with each bearing housing (
).
Figure 10
1.
Excluder seal
2.
Bearing housing
8
