Toro 03698, Operator'S Manual

Page: 14 / 28

2. Loosen the nut on the gauge bar ( Figure 23 )
and set the adjusting screw to the desired height
of cut.
g003327
Figure 23
1. Gauge bar 4. Holes used for setting
Groomer HOC
2. Height-adjusting screw 5. Hole not used
3. Nut
3. Measure the distance between the bottom of the
screw head and the face of the bar to get the
height of cut.
4. Hook the screw head on the cutting edge of the
bedknife and rest the rear end of the bar on the
rear roller (
Figure 24 ).
5. Rotate the adjusting screw until the front roller
contacts the gauge bar (
Figure 24 ). Adjust both
ends of roller until the entire roller is parallel to
the bedknife.
g003328
Figure 24
Important:
When set properly, the rear
and front rollers will contact the gauge
bar and the screw will be snug against the
bedknife. This ensures that the height of cut
is identical at both ends of the bedknife.
6. Tighten the nuts to secure the adjustment.
Note:
Do not overtighten the nuts. Tighten them
just enough to remove play from the washer.
14