g375232
Figure 5
1.
48 V system connector
2.
Battery-disconnect jumper
3.
At each cutting unit lift arm, remove the snapper
pin that secures the cap to the pivot yoke, and
remove the cap (
g003975
Figure 6
1.
Snapper pin
2.
Cap
Preparing the Cutting Units
1.
Remove the cutting units from the cartons.
2.
Assemble and adjust as described in the cutting
unit
Operator's Manual
.
3.
Make sure that the counterweight (
) is
installed at the proper end of the cutting unit as
described in the cutting unit
Operator's Manual
.
g027133
Figure 7
1.
Counterweight
4.
Coat the carrier-frame shaft with clean grease
(
).
g375263
Figure 8
1.
Carrier-frame shaft
5.
Repeat steps
through
for the other cutting
units.
13
