Procedure
Description
Qty.
Use
Carriage bolt (5/16 x 2-1/4 inches), Part
No. 3230-7—sold separately
1
Carriage bolt (5/16 x 3-1/4 inches), Part
No. 3230-13—sold separately
1
Carriage bolt (5/16 x 4-1/2 inches), Part
No. 3230-30—sold separately
1
Spacer
2
Flange nut (5/16 inch)
1
Locknut (5/16 inch), Part No.
3296-47—sold separately
2
Weight
2
13
Small weight (Part No.
132-0734-03—sold separately)
6
Install the weights (rear cutting unit with
groomer only, with rear grass basket).
14
No parts required
–
Finish installing the Universal Groomer
Drive Kit.
1
Preparing the Machine
For Cutting Units Installed on the
Machine
No Parts Required
Procedure
1.
Park the machine on a level surface.
2.
Engage the parking brake.
3.
Lower the cutting units.
4.
Shut off the engine, remove the key, and wait for
all moving parts to stop.
5.
Remove the cutting units from the machine; refer
to the
Operator’s Manual
for the traction unit.
2
Gathering the Tools
Required for Setup
Parts needed for this procedure:
–
Torque wrench (Not included)
Note:
Ensure that the torque wrenches are capable
of torquing both clockwise and counterclockwise.
•
Torque wrench—5.2 to 6.8 N∙m (46 to 60 in-lb)
•
Torque wrench—16 to 22 N∙m (12 to 16 in-lb)
•
Torque wrench—20 to 26 N∙m (15 to 19 in-lb)
•
Torque wrench—115 to 129 N∙m (85 to 95 ft-lb)
•
Torque wrench—135 to 150 N∙m (100 to 110 ft-lb)
•
Reel driveshaft tool, Part No. TOR4074
•
Long-handled pry bar (3/8 x 12 inches)
Service Tools
Oil syringe (included), Part No. 137-0872; refer to
Changing the Gearbox Lubricant (page 19)
.
Drive shaft tool (optional), Part No. 137-0920; refer
to your traction unit
Service Manual
or contact your
authorized Toro distributor.
3
Summary of Contents for 03240
Page 23: ...Notes...
