Toro 03240, Installation Instructions Manual, Page: 19 / 24

Transporting the Machine
When you wish to mow without the groomer or need
to transport the machine, move the quick-up lever to
the T
RANSPORT
position ( Figure 29 ).
Note:
This moves the groomer reel into a raised
position.
g287375
Figure 29
1. T
RANSPORT
position 2. O
PERATION
position
Maintenance
Changing the Gearbox
Lubricant
Service Interval
After the first 100 hours
Every 500 hours / Yearly (Whichever comes first)
1. Clean the external surfaces of the groomer
housing.
Important:
Ensure that there is no dirt or
clippings on the outside of the groomer
housing; if debris gets inside of the groomer
gearbox, damage may occur.
2. Remove the drain plug on the bottom of the
housing (
Figure 32 ).
3. Remove the fill plug on the side of the housing
and loosen the air-vent plug on the top so air
can pass through (
Figure 32 ).
4. Align a suitable container beneath the oil-drain
port to catch drained oil.
5. Tip the cutting unit back onto the kickstand
until the drain port is at the bottom to ensure
complete drainage (
Figure 30 ).
g346929
Figure 30
1. Remove the drain plug
from the drain port. 3. Loosen the air-vent plug.
2. Remove the fill plug from
the fill port.
6. Rock the cutting unit back and forth to ensure
complete drainage. When the oil is completely
drained, place the cutting unit on a level surface.
7. Install the drain plug.
19