Toro 03240, Installation Instructions Manual

Page: 4 / 24

3
Determining the Groomer
Gearbox Position
No Parts Required
Procedure
Use the following diagram to determine the position of
the groomer gearbox and reel motors.
g034633
Figure 2
1. Cutting unit 1 4. Groomer gearbox position
2. Cutting unit 2 5. Reel motor position
3. Cutting unit 3
Note:
If you are installing a groomer kit and you are
installing the rear roller-brush kit onto the cutting units,
install the groomer kit first.
4
Preparing the Cutting Unit
Parts needed for this procedure:
2 Extended splined insert (right-hand threads)
1 Extended splined insert (left-hand threads)
Removing the Front Roller and
Height of Cut Brackets
1. Loosen the 2 flange nuts (5/16 inch) and 2
capscrews (5/16 x 1-1/4 inches) and securing
front-roller shaft to the 2 height-of-cut brackets
(
Figure 3 ).
g356734
Figure 3
1. Capscrew (5/16 x 1-1/4
inches) and flange nut
(5/16 inch) 3. Height-of-cut bracket
2. Carriage bolt (3/8 x 1-1/2
inches) 4. Flange locknut (3/8 inch)
2. Remove the flange locknut (3/8 inch) and
carriage bolt (3/8 x 1-1/2 inches) securing the
height-of-cut (HOC) bracket to the cutting-unit
side plate (
Figure 3 ).
Note:
Retain the carriage bolt (3/8 x 1-1/2
inches).
Discard the flange nut (5/16 inch), capscrew
(5/16 x 1-1/4 inches), and flange locknut (3/8
inch).
4