board.
2.
Slightly loosen the nuts securing the roller brackets
to the angle brackets.
3.
Adjust the support capscrews to achieve16 mm+ 2
mm dimension between the height-of-cut support
and roller bracket (2 places).
4.
Remove the hairpin cotters securing the height-of-
cut pins and install them in the hole at the desired
setting shown on the height-of-cut plate
Figure 44
1. Roller
bracket
2. Angle
bracket
3. Height-of-cut
pin
4. Support
capscrew
5. Skid
5. Use a gauge block with a thickness equal to the
desired height of cut and position it against the front
edge of the bedknife at one end. Turn the support
capscrew to adjust the height of the bedknife equal
to the gauge block.
6.
Repeat the procedure at the other end; then recheck
the original end.
7.
Tighten the nuts securing the roller brackets.
8.
Height of cut may be changed by re-positioning the
height-of-cut pins to the desired setting.
9.
Adjust the skids 1/8" to 1/4" higher than the height-
of-cut setting.
ADJUSTING THE BEDKNIFE
PARALLEL TO THE REEL
(Fig. 45-46)
(Floating or Fixed Cutting Units)
1.
Make sure the reel contact is removed by turning
the bedknife adjustment knob counterclockwise
(Fig. 45). Tip the cutting unit to gain access to the
reel and bedknife (Fig. 46).
Figure 45
1. Bedknife adjusting screw
2.
On either end of the reel, insert a long strip of dry
newspaper between the reel and bedknife. While
slowly rotating the reel into the bedknife, turn the
bedknife adjusting knob clockwise, one click at a
time until the paper is pinched lightly, which results
in a slight drag when the paper is pulled.
3.
Check for light contact at the other end of reel using
paper. If light contact is not evident, proceed to next
step.
4.
Loosen the (2) carriage bolts on the bedbar adjuster
(Fig. 46).
5.
Adjust the nuts to move the bedbar adjuster up or
down until the paper is pinched along the entire
bedknife surface, when the bedknife adjustment
knob is adjusted to no more than two clicks beyond
first contact of the reel bedknife.
6.
Tighten the nuts and carriage bolts and verify
adjustment.
Maintenance
32
1
Summary of Contents for 02000 GROUNDS PRO 2000
