Figure 40
1. Reservoir
2. Hose
assembly
Note: To drain the oil remaining in the system,
disconnect the spark plug wires and crank the
engine for 15 seconds. This will pump the
remaining oil out of the system. Do not crank the
engine for more than 15 seconds.
4.
Install the new hydraulic filter to the filter housing.
5.
Install the tube assembly and hose assembly to the
reservoir.
6.
Fill the reservoir to the proper level; refer to Check
Hydraulic System Fluid.
7.
Place all controls in the neutral or disengaged
position and start the engine. Run the engine at the
lowest possible RPM to purge air from the system.
8.
Run the engine until the lift cylinder extends and
retracts and forward and reverse wheel motion is
achieved.
9.
Stop the engine and check the oil level; add oil if
necessary.
10. Check all connections for leaks.
CHANGING THE HYDRAULIC OIL
FILTER (Fig. 40)
The hydraulic oil filter must be serviced at regular
intervals. The intervals are: initially, after the first 8
hours of operation, and thereafter every 200 hours of
operation or yearly, whichever comes first. Use a
genuine TORO oil filter for replacement.
1.
Remove the hydraulic oil filter from the mounting
head.
2.
Apply a film of oil on the gasket. Install the filter by
hand until the gasket contacts the mounting head;
then tighten the filter an additional 3/4 turn.
3.
Start the engine and check for oil leaks. Allow the
engine to run for about two minutes to purge air
from the system. Then shut off the engine.
4.
Check the level of oil; refer to Check the Hydraulic
System Fluid.
CHANGING FRONT AXLE OIL
(Fig. 41)
After every 400 hours of operation, change the oil in the
front axle.
1.
Drive the machine for five minutes before changing
oil to warm the axle oil. Warm oil flows more freely
and carries more contaminants than cold oil.
2.
Clean the area around the drain plug and place a
drain pan below the drain plug on axle.
Figure 41
1. Drain
plug
2. Fill
plug
Remove the drain plug and allow the oil to flow into
drain pan. After the oil is drained, reinstall drain plug.
Remove the fill plug and fill to plug level with ISO
150/220 (SAE EP-90) oil (approximately 44 oz.).
Maintenance
29
1
2
1
2
Summary of Contents for 02000 GROUNDS PRO 2000
