17
3. The disk scrub head is equipped with a self-adjusting shroud with bristle skirt that virtually eliminates
overspray and increases the ease of use.
Lowering the squeegee assembly
ACTIVATING THE SCRUBBER
1. To begin scrubbing, engage the handle trigger. The trigger activates solution flow, the brush motor and
traction drive, if equipped. This unique, ergonomic design accommodates different operator heights by
allowing the user to activate the trigger from any position on the handle.
2. The speed control and reverse switch on the traction drive models are purposely located so that the
operator doesn’t have to let go of the machine with either hand to perform the function. Speed control is
easily thumb adjusted and the reverse can be depressed with your fingers on the back side of the control
housing.
3. This one-handed reverse feature allows the operator to lift the squeegee with the other hand – a small
element with big rewards when in tight spaces.
LOWERING THE SQUEEGEE
To lower the squeegee, lift the squeegee lever and shift it left to clear
the notch. Once clear, lower the squeegee into the recovery position. In
doing so, the unit’s vacuum motor will activate.
TRANSPORT MODE
The scrub deck and squeegee must be in the raised position for transport.
1. The scrub deck is raised into transport position by placing your foot on the foot pad and depressing the
lever until it clears the lower notch. Once clear, shift the lever to the left and place it into the lower notch.
2. To raise the squeegee, lift the squeegee lever high enough to clear the notch, shift it to the right and lower
it into the resting position. The vacuum will continue to run for 10 seconds in order to evacuate the recovery
hose.
Reverse switch is easily reached with
fingertip
3
Speed control adjustment
2
Activating the handle trigger
1
Self-adjusting head shroud with bristle
skirt
3
Summary of Contents for Floorkeeper 28 OB/99128OB
Page 3: ...3 NOTES...
